• 
• 
• 
• 
• 

延安除銹劑，噴砂施工程序 施工準備——安裝——設備調試——試噴——檢驗——調整——噴砂施工——檢查驗收 （3）噴砂除銹原理 1）噴砂清理就是以壓縮空氣為動力，帶動磨料通過專用噴嘴。高速、高壓噴射于金屬表面， 達到除銹的目的。 2）空壓機是噴砂清理的主動力，把壓縮空氣和磨料的流量調整到狀態，使磨料達到足夠的出口速度，清理效果。由于壓縮空氣與噴砂軟管和接頭的磨擦，噴砂嘴處的壓力要下降很多，經測定，當空壓 機的排氣壓力為0.7Mpa時，噴嘴處的工作壓力通常只剩下0.5Mpa-0.56Mpa。而在采用砂子作磨料時，當噴嘴壓力達0.63Mpa-0.77Mpa時，清理效果