2、針對槽鋼剪刃設計存在的問題，結合生產實際情況，將剪刃設計為圖2所示的形狀(以100#槽鋼為例)。上剪刃寬度由100mm改為99mm，減少上剪刃在左右方向的間隙，改善槽鋼兩角部的剪切質量;下剪刃兩角部圓弧尺寸由R8mm改為R7mm，提高兩角部的剪切重疊量，改善槽鋼肩部剪切質量;下剪刃上邊寬度由79mm改為80mm，下邊寬度由97mm改為94mm，使下剪刃腿端斜度小于槽鋼成品孔型斜度，這樣在腿部剪切時，腿部上、下方向上不會同時受力，從而減少剪切力，改善剪切質量。